Tube Phosgene 0.02/a (10) | Draeger

Tube Phosgene 0.02/a (10) is a single-use colorimetric detector tube designed for rapid on‑site measurement of phosgene (COCl₂) in air. Each tube contains a proprietary reagent that produces a clearly visible colour change proportional to airborne phosgene concentration when used with a compatible hand pump or diffusion sampler. Tubes are supplied in a pack of ten and are intended for field checks, industrial hygiene surveys, emergency response, and confined‑space safety monitoring where quick, portable detection is required.

Key features

• Pack size: 10 tubes per pack

• Detection principle: colorimetric reagent (visual reading of stain length or comparison with a scale)

• Typical lower detection sensitivity: ~0.02 ppm (suitable for low‑level detection; see specifications below)

• Quick response — typically one measurement in under 1–2 minutes when used with a hand pump (actual sampling time dependent on pump and stroke count)

• No power required — handheld, portable, disposable

• Clear, high‑contrast colour change for easy reading in the field

• Individually sealed tubes to preserve shelf life

Typical specifications (representative — confirm with supplier)

• Measurement range: 0.02 to 2.0 ppm (examples; some tube variants cover different upper ranges)

• Accuracy: ±15–25% of reading under recommended sampling conditions

• Cross‑sensitivity: possible interference from other reactive chlorine‑containing or oxidizing gases — consult supplier interference chart

• Operating temperature: 0–40 °C (verify with manufacturer)

• Shelf life: 12–24 months when stored sealed at recommended conditions (cool, dry, away from sunlight)

• Tube dimensions: approx. 60–100 mm length, 6–8 mm diameter (varies by manufacturer)

Note: The above numerical specs are typical for colorimetric phosgene detector tubes. Please confirm exact values, lot‑specific expiry and interference data with the product datasheet or supplier before use.

Intended uses

• Rapid screening for phosgene leaks in industrial plants (chemical manufacture, fumigation processes, chlorinated solvent operations)

• Emergency response and leak assessment by HAZMAT teams

• Personal or area monitoring as part of industrial hygiene surveys (short‑term checks)

• Confined space entry pre‑checks (as one line of evidence; not a substitute for full gas‑monitoring programs)

Safety & precautions

• Phosgene is an extremely toxic pulmonary irritant. These tubes detect phosgene only — do not rely solely on tubes for full personal protection decisions when high concentrations or unknown situations are present.

• Use appropriate personal protective equipment (PPE): respirator/SCBA, chemical‑resistant gloves, eye protection, and protective clothing as required by the hazard assessment.

• Handle tubes carefully to avoid breakage and accidental exposure to tube reagents.

• Do not attempt to open or reuse tubes. Used/broken tubes should be treated as chemical waste.

• Keep away from incompatible materials and store in a cool, dry, dark place per supplier instructions.

• Consult the product Safety Data Sheet (SDS/MSDS) for reagent hazards, first‑aid, and spill response procedures.

Limitations

• Colorimetric tubes give semi‑quantitative results and can be affected by humidity, temperature, sampling technique, and interfering gases.

• Not intended to replace continuous monitoring where continuous real‑time data and alarms are required.

• For regulatory compliance or definitive exposure assessment, follow up with calibrated instrumental methods (e.g., FTIR, GC with appropriate sampling) as required by your local regulations.

Packaging & storage

• Pack: 10 tubes in a sealed blister or foil pouch (depending on manufacturer)

• Storage: sealed, in original packaging; recommended storage temperature and maximum shelf life printed on each pack/label

Regulatory & documentation

• Each pack should be supplied with: lot number, expiry date, instructions for use, and a product datasheet/SDS. Verify compatibility with local occupational exposure limits (OELs) and regulatory requirements before use.